Harbor Sun Lounger Cover

What this cover is

The Harbor Sun Lounger Cover is a protective cover for a sun lounger or patio lounge chair. It is made of cloth with a waterproof finish, so rain and moisture stay off the furniture underneath. The plain black color blends in with most patio setups and looks tidy on a deck, by a pool or on a lawn.

This is a simple cover with a clear job: shield your lounger when it is not in use. It suits recliners and lounge chairs with a long, low profile. If you store cushions on the lounger, the cover helps keep them dry too.

Sizes

Two sizes are available. Check the length, width and height of your lounger before you order. Measure at the widest points, including any armrests or a raised back.

The two sizes are close. The 83 in (210 cm) option is about 1 in (2 cm) longer and about 1 in (1 cm) narrower than the 82 in (208 cm) option. Pick the one that best matches your lounger.

Pack options

You can order a single cover or a 2 cover pack. The 2 cover pack is handy when you have two loungers side by side, or when you want a spare on hand. Each cover in the pack is the same size and color.

Available choices:

• 82 x 30 x 31 in (208 x 76 x 79 cm), 1 cover
• 82 x 30 x 31 in (208 x 76 x 79 cm), 2 covers
• 83 x 30 x 31 in (210 x 75 x 80 cm), 1 cover

How to use it

Let your lounger dry if it is wet, then drape the cover over the top. Pull it down over the back, seat and foot end so the fabric hangs evenly on all sides. Smooth out folds so water runs off instead of pooling. Tuck the lower edges under the frame if you want a snugger hold on windy days. When you are ready to use the lounger, lift the cover off and set it aside.

Care

Rinse the cover with water to remove dust and dirt. Let it dry fully before you store it. Store it folded in a dry place. Do not put it away damp, since trapped moisture can cause mildew over time. A quick rinse and a full dry are all it needs to stay ready for the next season.